| 備考 |
柏葉付騎士鉄十字章の実物と思われますが、詳細不明です。20年ぐらい前には、180万円ぐらいで取引されていた希少品です。ちなみに、この勲章の受章者はドイツ軍人882名、ルーマニア陸軍将官3名、スペイン義勇部隊将官1名、日本海軍将官2名、フィンランド軍将官1名、ベルギー人義勇部隊将校1名。一般的に柏葉章以上の授与式では、ヒトラーから直接賜与され、空軍将兵の場合は授与後にゲーリングの謁見を受ける慣わしがあったようです。当品は、ネックリボン用サスペンションループが柏葉章に差し替えられて騎士鉄十字章本体に装着されているものです。騎士鉄十字章・柏葉章ともに、手作業により丹念に仕上げられた極めてハイクオリティな造りの品です。騎士鉄十字章は、縦48.9（本体上端の環状突起部を除く）×横48.0×厚さ4.4mm、35g（重量は、騎士鉄十字章と柏葉章との合計）。アイアンコア（磁石による吸着確認済み）をシルバーフレームでサンドイッチにした標準的なスリーピース造り。フレーム外側は、鏡面仕上げで、酸化変色・くすみは殆ど無し。内側のギザギザのミリング部分には艶消しの白色酸化仕上げがほぼ残存。コア部の黒色塗料は、滑らかな半艶消し仕上げ。表裏両面ともに剥離・傷は僅かで綺麗に残存。フレーム裏面の環状突起部直下に銀含有量刻印“800”。製造所刻印は無し。柏葉章は、長径20.5×短径19.2×厚さ3.5mm（サスペンションループを除く本体部分）。本体は、一体成形で、厚みとずっしりとした量感のある銀塊様の品。表面は、彫りの深い梨子地仕上げで、中央の葉脈とエッジ部分とが磨き上げ。裏面は、凹面鏡様の形状で鏡面仕上げ。表裏両面とも酸化変色・くすみは殆ど無し。裏面右下に銀含有量刻印“800”。製造所刻印は無し。ネックリボンは、襟元に留めるためリボンタイ式にカットされ、完品ではありませんが、折り畳んでケース内に収納するとノーカット状態と同様に見えるように配慮されています。リボン本体の両端には、赤い布地（リボン本体の赤地部分とは異なる布地）で仕立てた細いリボンが縫い付けられています。リボン本体は、幅4.5×長さ19.0cm、細いリボンは、各々幅0.7×長さ11.0cm。退色・変色は殆ど無く、若干の折り皺以外には、破れ・ほつれなどの目立つダメージも無し。ケースは、四隅が角張ったタイプで、縦14.9×横7.5×厚さ2.6cm。蓋の表面が無刻印なので、官給品と思われます。内部は、蓋が白いサテンまたはレーヨン張り、本体が黒いベルベット張りの標準的な造りで、布地の変色は殆ど無し。底面に目立たない程度の若干の擦過痕がある以外には、ケース本体や蝶番・留め金の破損などのダメージは無し。当品は、柏葉章が騎士鉄十字章に装着されているため、騎士鉄十字章のリボン用ループおよび柏葉章のリボン・ケースは、入手当時からありません。当品の保存状態は、入手当時と変わらず、極めて良好。発錆・大傷・フレームの歪みなどのダメージが無いことは勿論、上述のとおり、経年による各部の劣化なども極僅かです。洗浄、リペイントなど後年に手を入れた形跡も、当方が目視した限りでは見当たりません。全体に使用感は認められず、数十年の時の経過を忘れさせる極美品。リボンがカットされていることから、全くの未使用では無いものの、数回佩用した程度の使用状態と思われます。I seem to be the real thing of a knight iron cross chapter belonging to oak leaf, but am missing in detail. Around 20 years ago, it is a rarity had dealings for around 1,800,000 yen. By the way, the person of receipt of a prize of this decoration is 882 Germany officers, Romania army general 3, Spanish loyalty and courage corps flag officer 1, Japanese Navy flag officer 2, Finnish admiral official 1, Belgian loyalty and courage corps officer 1. In the investitures more than Hakuyou chapter, it was done 直接賜与 by Hitler, and there seems to have been generally a custom to receive an audience of Goring after the conferment in the case of the air force officers. A suspension loop for neck ribbon is replaced with Hakuyou chapter, and this article is attached to the main body of knight iron cross chapter. I resemble knight iron cross chapter / the oak leaf chapter, and it is the finished article which is be a high quality extremely made by manual labor carefully. The knight iron cross chapter 48.9 in height (except the ringed tang of the main body upper end) X 48.0* in width thickness 4.4mm, 35g (the weight, total with knight iron cross chapter and the oak leaf chapter). The standard three-piece structure that I made a sandwich with an iron core (I finish adsorption confirmation by the magnet) silver frame. I seem to finish it, and I am dark, and, in the frame outside, there is no mirror side in the most an oxidation change of color. Mat white oxidation finish almost remains in an inside notched milling part. The atrament of the core part finishes it with fluent half mat. Front and back both sides remain neatly together whether there are a little detachment / wounds. Right under the ringed tang of the frame back side silver content carved seal "800." There is no factory carved seal. The oak leaf chapter 20.5* 19.2* longer axis minor axis thickness 3.5mm (a body portion except the suspension loop). On earth the main body is an article thickness and silver bullion with the volume that I did heavily-like by molding. A central leaf vein and edge part polish it and give the surface by the aventurine lacquer finish that the carving is deep. The back side finishes it with a mirror side with concave lens-like shape. I am dark, and there are no most an oxidation change of color with the front and back both sides. In the back side lower right silver content carved seal "800." There is no factory carved seal. The neck ribbon is cut by Thai ribbon type to keep it to neck, and it is not 完品, but it is considered to be seen like a no cut state when I fold it and receive it in a case. The thin ribbon which I sewed in a red piece of cloth (a piece of cloth unlike the Akachi part of the main body of ribbon) is sewed on the both ends of the main body of ribbon. As for the main body of ribbon, as for 4.5* in width 19.0cm in length, the thin ribbon, it is each 0.7* in width 11.0cm in length. As for fading / the change of color, there is no it in the damage that a tear / the raveling is outstanding besides the some occasion wrinkles without most. By the type that the four corners were square-built as for the case, it is 14.9* in height 7.5* in width thickness 2.6cm. Because the surface of the cover is no carved seal, I seem to be a government issue. The satin that a cover is white or rayon tension, the main body are standard made black velvet Rino Cho, and there is almost no change of color of the piece of cloth in the inside. There is no it in the damage such as the main body of case or the damage of a hinge / the clasp except that there are some excortication traces of the degree that is not outstanding in a base. Because Hakuyou chapter is attached to a knight iron cross chapter as for this article, there are not a loop for ribbon of the knight iron cross chapter and the ribbon case of the Hakuyou chapter from acquisition those days. The state of preservation of this article is extremely good without changing at the time of acquisition. Not to mention there not being the damage such as the distortions of the large wound / frame departure from rust, the deterioration of each part by the aging is the pole few according to the statement above. Washing, re-paint are not found as far as we saw the trace that they put a hand in later. The pole beauty product to let a feeling of use is not accepted by the whole and forget progress at the age of dozens of years. Because ribbon is cut, it seems that use of the degree that did few times is in a state although I am really unused, and there is not it. |
